Quickly change your existing kegorator for use with Homebrew or soda C-Kegs. Easily switch the connectors and taps depending on what you are dispensing in just seconds.
To install: Cut your CO2
line about three inches before the tap. Insert the barbed male quick disconnect into the end of three inch line coming from the tap and fasten with a clamp. Then insert the female quick disconnect into the end of the line coming from the regulator and fasten with a clamp. The liquid side switches by simply moving the shank nut over to the liquid disconnect adapted for shank thread.
|1ea 1/4'' Female in-line Quick Disconnect||2ea 1/4'' Male in-line Quick Disconnect||3" CO2 line.|
|Gas Disconnect||2ea Stepless Clamps and 2ea Screw Clamps||Liquid Disconnect adapted to shank thread.|